Messoa NDR891 Manuel d'utilisateur télécharger pdf (Page 10)

2. Camera Installation

CAUTION! For heater model, the dome cover should NOT be removed over 30 minutes during

installation. Otherwise, the desiccant will absorb too much moisture causing vapor when heater is on. 

2.1 Ceiling Mount

1. Remove the dome cover and the inner liner.

Use a security torx screwdriver to loosen (but not remove) the 3 cover screws.

Remove the inner liner by gently pulling it free from the two notches on the camera base.

2. Use the Guide Pattern Sticker to drill the mounting holes.

Place the provided “Guide Pattern Sticker” on the desired mounting location. Drill three mounting

holes and one cable entry hole according to the guide pattern.

3. Connect the wiring and optionally insert the SD card.

Draw out the cabling to the connecting places. Refer to “1.3.2 Connectors” section to make

connections as required. If using SD card function, insert the Micro SD/SDHC card.

To adjust the field of view and focus, you can optionally connect a monitor to the Video out RCA jack

at this point. If no monitor is available, then focus must be performed by using an Internet browser to

view the camera images.

Caution: For DC power supply use, make sure the polarity is correct to avoid malfunction and / or

camera damage.

4. Secure the camera base to the surface.

Use appreciate screws according to the mounting surface material. If required, you may require

different screws and anchors than those supplied.

For cement surface:

Insert the provided plastic anchors into the three drilled holes. Then secure the camera base to the

mounting surface with the provided tapping type screws.

For metal plate surface:

Do not use the plastic anchors. Just secure the camera base to the mounting surface with the

provided machine type screws.

5. Adjust the camera position and focus.

Adjust the focusing position by rotating and panning the camera base. Adjust the lens using the Zoom

and Focus controls.

6. Install the inner liner.

Fit the camera liner over the camera base so that it snaps into place.

7. Replace the dome cover.

Put the dome cover over the base and tighten the 3 cover screws.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Pas de commentaire

Messoa NDR891 Manuel d'utilisateur Page 10